K40 lightburn board12/20/2023 That the DTR control is activated (Edit/Device Settings).That the USB connection speed is correct (Edit/Device Settings): it should be on 115200 bauds.If so, your computer and laser cutter connected as intended. You should see indications similar to the one below on the console: ![]() ![]() This will restart the USB/Serial connection between Lightburn and the ESP32. Now right click on the “Devices” button in the right column. Then, under Lightburn, click on the “Console” tab in the right column. We will start by testing the connection of the ESP32 to your PC without installing the shield in the K40.Ĭonnect the USB cable from your PC to your ESP32 Please start by installing Lightburn following my instructionsĬonnecting the K40 FluidNC Shield to your computer The use and implementation are very similar to the previous version
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |